Less Twisting. More Saturday Left.
Strip. Lift. Insert. Clamp It Shut.
Start with power disconnected and verified off. Strip about 0.4 inches of insulation, raise the lever to 90°, insert the wire fully, then press the lever down. That solid lever snap replaces the fiddly twisting step, so you can get on with your lighting project.
You Notice The Wiring Nobody Sees
You're the person who lines up the tools before starting and takes pride in what sits behind the cover. The compact 2-in, 2-out layout gives your wires separate entry points. Red and blue levers keep those connection points visually distinct—a small detail that suits the way you work.
Wires Stay Locked. Vibration Proof.
Inside, thickened copper strips grip the wire with enough tension to resist vibration and movement. That tight, mechanical hold eliminates the slow creep-loose that plagues twisted connections. Once you press the lever down, the wire isn't going anywhere—so you can finish your project instead of redoing loose connections later.
Check It Without Pulling It Apart
You shouldn't have to dismantle a connection just to reach a test point. Rear test holes provide inspection access without removing the wires. Changing your LED layout later? Disconnect power and verify it is off, then reopen the lever to release and reconnect the wire.
Reusable Connectors for Every Project
This 10-pack outlasts any one-time project. LED retrofit, junction box cleanup, automotive rewire—reopen the lever and reconfigure for the next job.
Leave The Twisting Behind
Compared with twist-and-tape connections, you get individual lever clamps, separate entry ports and built-in test access. Make the connection without winding wires together.
|   | Joygrova | Twist-and-tape |
|---|---|---|
| Skip twisting wires together | ||
| Rework connections with reusable levers | ||
| Keep wires in separate entry ports | ||
| Distinguish connections with colored levers | ||
| Inspect through integrated test holes | ||
| Connect through thickened copper strips |
Product Facts, Not Customer Testimonials
Before You Open The Toolbox
Will these fit my wire?
Will these fit my wire?
The pictured guide lists solid and stranded wire at 28–12 AWG, and flexible wire at 28–14 AWG. Follow the range for your wire type rather than assuming every wire fits the full range.
Can I disconnect and reuse them?
Can I disconnect and reuse them?
Yes. The lever mechanism lets you release and reconnect a wire instead of discarding the connector after one use. Make adjustments only with power disconnected and verified off.
Do I have to remove wires for testing?
Do I have to remove wires for testing?
No. Rear test holes provide inspection access without removing the wires. Use appropriate test equipment and safe electrical practices; test access does not make an energized circuit safe to touch.
What exactly comes in one pack?
What exactly comes in one pack?
You get 10 reusable lever-type connectors in the 2-in, 2-out configuration. Each has a compact PC housing, red and blue operating levers, and integrated test holes.